![]() ![]() All users that you create in ISPConfig via "Sites -> Web Access -> FTP Accounts" are virtual users, which are mapped to system users when logging in via FTP. Make sure you can at least connect with system users via FTP. ![]() This is only relevant if you use ISPConfig for multiple combined servers. If you have "Replication failed" errors in the job queue, sync ISPConfig versions across servers.Check in ISPConfig in "Monitor -> System State -> Show Jobqueue" to make sure it's empty, or if not, fix this as shown here. But if it fails, the job queue can get stuck. In ISPConfig, your tasks (like creating an FTP user) get processed deferredly by a cron job that runs every minute. At some webhosters, the actual username would be something like This is not required for ISPConfig FTP logins, and probably would not work either. You do not have to include the domain name into the user name.Just as you see the username listed in "Sites -> FTP Accounts" in column " username". So when setting up your FTP client, do not just use the username you entered, but put that prefix before. If the prefix uses " c" in that form, it might be " c1" for example. Did you include the ISPConfig username prefix? In ISPConfig, when you create a FTP user, SSH user etc., the panel will prepend this username with a prefix that you can configure in "System -> Interface -> Main Config -> Sites".I have roughly ordered them into a logical order of things to check, starting from frequent causes. This problem can have several reasons, so you should try the following alternatives. Nov 19 16:48:53 one pure-ftpd: pam_unix(pure-ftpd:auth): authentication failure logname= uid=0 euid=0 tty=pure-ftpd ruser=c1testuser rhost= Solution Nov 19 16:49:00 one pure-ftpd: Logout.Īnd something like this in /var/log/auth.log: Nov 19 16:49:00 one pure-ftpd: Authentication failed for user Nov 19 16:48:53 one pure-ftpd: PAM_RHOST enabled. Nov 19 16:48:53 one pure-ftpd: New connection from Response: 530 Login authentication failedĬoncurrently, you would see something like this in /var/log/syslog: Then you create a website in ISPConfig, create an FTP account for it in ISPConfig, try to log in with this account, and it does not work. In this case, I used the setup instructions for ISPConfig 3 on Debian 7.0 Wheezy with Apache2, BIND, Dovecot. You have installed the ISPConfig server admi panel (in my case, version 3.0.5.3), all according to their guidelines called "The Perfect Server". ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |